$ loading_
Automate LTspice simulations, schematics, verification, and data extraction with natural language.
Copy the install command and let the AI configure it · recommended for beginners
No copy-paste install info for "ltspice-mcp" yet — see the docs or source repo.
Create an RC low-pass filter schematic in LTspice with R=1kΩ and C=100nF, use a 1V AC input, run an AC sweep from 10Hz to 100kHz, and export the frequency response data plus a schematic preview.
A runnable LTspice schematic, simulation setup, frequency response data file, and a schematic or results preview.
Check whether a common-emitter amplifier design meets a midband gain target of 20dB±1dB. Run the simulation, extract key measurements, state pass or fail, and suggest possible adjustments if it does not meet the target.
A verification result with key gain measurements, a pass/fail decision, and actionable tuning suggestions.
Run a 5ms transient simulation for a switching power supply circuit, extract output voltage and inductor current waveform data, calculate ripple peak-to-peak values, and package the results into CSV files for further analysis.
Transient simulation results, exported key waveforms, ripple calculations, and structured CSV data.
Read, edit, simulate, and plot LTspice circuits using natural language.
Connect AI to LTspice and ngspice for circuit design and simulation.
Generate, simulate, and inspect LTspice circuits through structured agent-friendly interfaces.
Design and verify circuits with natural-language SPICE simulation and netlist automation.
Lets AI design RF filters and SMPS-EMC circuits from specs with compliance checks.
Use AI to automate KiCad schematic, PCB, footprint, and project workflows.