$ loading_
Control a programmable DC power supply for measurements, output, and memory tasks.
Copy the install command and let the AI configure it · recommended for beginners
No copy-paste install info for "rs3005p-mcp" yet — see the docs or source repo.
Set the RS-3005P power supply to 12V and 1.5A, turn the output on, and return the configured and measured values.
The power supply is configured and output is enabled, with returned setpoints and live voltage/current readings.
Output 3V, 5V, and 9V in sequence, hold each for 10 seconds, read voltage and current once at each step, then turn output off and summarize the results.
A stepped power sequence is completed, measurements are logged for each step, and a concise test summary is produced.
Save the current 24V, 0.8A configuration to memory slot 2, then recall slot 2 and confirm the parameters match.
The current configuration is saved to the specified memory slot, then successfully recalled and verified.
Access RS232 serial ports via MCP for listing, opening, reading, and writing.
Let AI control oscilloscopes for waveform capture and measurement analysis.
Control a bench oscilloscope over LAN for hardware debugging and validation.
Connect to Cisco routers and switches over serial consoles with automated prompt handling.
Control lab automation devices via MCP and test workflows in simulation.
Control a PicoScope 5000A for capture, measurement, sweeps, and signal generation.