$ loading_
Communicate with embedded and IoT devices over serial for debugging and control.
Copy the install command and let the AI configure it · recommended for beginners
No copy-paste install info for "embedded-serial-mcp" yet — see the docs or source repo.
List the currently available serial devices, connect to /dev/ttyUSB0 at 115200 baud, and report the connection status.
A list of available serial ports, plus the connection result and status for the target port.
After connecting to the serial port, send AT+VERSION?, read the response, and format the result as command-response pairs.
The sent command, the device response data, and a concise formatted summary.
Continuously monitor the connected serial port for 60 seconds, record all received data, and flag any log lines containing error, fail, or timeout.
A serial log record with suspected errors or failures clearly highlighted.
Open, read, write, and manage serial ports through MCP for device workflows.
Access RS232 serial ports via MCP for listing, opening, reading, and writing.
Connect to serial devices for port control, data exchange, and protocol handling.
Automate embedded firmware build, flashing, reset, and serial log capture.
Read, edit, and optionally compile Arduino sketches through an MCP bridge.
Connect MCP to ESP32 Tasmota devices for structured control and sensor reading.