$ loading_
Control NI oscilloscopes with AI for acquisition, measurement, and configuration.
Copy the install command and let the AI configure it · recommended for beginners
No copy-paste install info for "niscope-mcp" yet — see the docs or source repo.
Connect to an NI PXIe-5164 oscilloscope, acquire the waveform from channel 0, set the sample rate to 500 MS/s and record length to 1e6 points, then return peak-to-peak voltage, frequency, and RMS voltage.
A waveform acquisition result with key measurements and basic acquisition settings.
Set channel 0 and channel 1 on the PXIe-5110 to a ±2 V input range, use DC coupling, set the trigger source to channel 0 with a rising-edge trigger, and summarize the current configuration.
Confirmation that channel and trigger settings were updated, plus a summary of the current instrument configuration.
Run 20 consecutive acquisitions on a PXIe-5160, capture the waveform from channel 1 each time, calculate the peak value, and finally summarize all runs with the maximum, minimum, and average.
A list of measurement results for each run and summary statistics for test analysis.
Let AI control oscilloscopes for waveform capture and measurement analysis.
Control a bench oscilloscope over LAN for hardware debugging and validation.
Connect AI to an Owon oscilloscope for capture, measurements, and remote control.
Control Rigol oscilloscopes with AI through automated SCPI command execution.
Control a PicoScope 5000A for capture, measurement, sweeps, and signal generation.
Control USB oscilloscopes with AI for waveform capture and measurements.