$ loading_
Automate embedded firmware build, flashing, reset, and serial log capture.
Copy the install command and let the AI configure it · recommended for beginners
No copy-paste install info for "Firmware MCP Server" yet — see the docs or source repo.
Use the device configuration file to build the latest firmware for the target board and flash it to the device; if the build fails, return the error log and likely causes.
Returns the build result, flashing status, and a diagnostic summary if it fails.
Reset the connected device and capture serial logs for the first 60 seconds after boot, then summarize key errors, boot stages, and abnormal messages.
Outputs the raw serial log along with a chronological summary of key events.
Run build, flash, reset, and log capture sequentially for multiple devices in the test configuration, and mark which devices boot successfully and which show anomalies.
Generates a per-device execution summary with success status, failed step, and log anomaly notes.
Communicate with embedded and IoT devices over serial for debugging and control.
Open, read, write, and manage serial ports through MCP for device workflows.
Read, edit, and optionally compile Arduino sketches through an MCP bridge.
Access RS232 serial ports via MCP for listing, opening, reading, and writing.
Run FPGA toolchain tasks from linting and simulation to synthesis and programming.
Configure and manage MCP servers across multiple transport modes.