$ loading_
Automate build, flashing, serial capture, and relay control for ESP32-S3 boards.
Copy the install command and let the AI configure it · recommended for beginners
No copy-paste install info for "autotest_iot" yet — see the docs or source repo.
Use autotest_iot to build and flash firmware to the specified ESP32-S3 board, then capture serial logs for 5 minutes and return the build result, flash status, and a summary of key error logs.
A complete build, flash, and serial capture report with summarized anomalies.
Use autotest_iot to power-cycle the target board via relay, reflash the test firmware, capture boot serial output, and identify the symbolized stack trace that may explain the crash.
Reset and flashing results, boot logs, and analysis of the symbolized crash stack trace.
Use autotest_iot to run tests concurrently across multiple ESP32-S3 boards while respecting per-board locks to avoid conflicts, then summarize each board's job status and test logs.
A board-by-board concurrent test report including lock usage, job outcomes, and log summaries.
Connect MCP to ESP32 Tasmota devices for structured control and sensor reading.
Automate embedded firmware build, flashing, reset, and serial log capture.
Communicate with embedded and IoT devices over serial for debugging and control.
Let AI read, control, and debug microcontrollers over serial connections.
Search STM32 docs and get embedded development assistance.
Debug embedded Linux targets via serial with logs, recovery, and control.